Uwell Valyrian Pod Replacement Coils

The Uwell Valyrian Pod Replacement Coils let you fit a new coil without replacing the whole pod, so you keep the refillable pod and swap only the coil. The coil is located at the bottom of the pod, and installation is push-fit. Available in 0.6 Ohms for direct-to-lung (DTL) vaping and 1.0 Ohms for mouth-to-lung (MTL), both FeCrAl and supplied in a pack of 4.

These coils are also compatible with the Uwell Valyrian SE Pod System, which uses the same 0.6 and 1.0 Ohms coils. The Valyrian Pod Kit and the SE both have a maximum output of 25 W.

Two Valyrian Platforms

These coils are made for the Uwell Valyrian Pod Kit, the Valyrian SE Pod System and the Valyrian Pod replacement cartridges. Nothing else.

Please note: the Valyrian tanks are not compatible with these coils, and a 0.6 or a 1.0 Ohms coil will not work in a Valyrian tank. If you have one of those tanks, the Uwell Valyrian 3 Replacement Coils are the coils for the Valyrian 3.

Uwell also makes a FeCrAl 1.0 Ohm Caliburn G Coil, sold separately for the Caliburn range. The resistance is the same, but it is a Caliburn coil and it is not compatible with the Valyrian Pod: a Caliburn G or G2 owner wants the Uwell Caliburn G / G2 Replacement Coils instead.

The Draw Each Coil Gives

Choose by how you like to inhale:

• Direct-to-lung - the 0.6 Ohms, for a smooth airflow and a thick cloud
• Mouth-to-lung - the 1.0 Ohms, for a tight draw

We advise using 50/50 e-liquids or nic salts with both coils, as the pod works better with thinner e-liquids than thick, high VG blends.

Lower-Cost Replaceable Coils

Each pack contains four coils, and all four fit the pod you already have. Replacing the coil rather than the pod is the cost-effective way to keep a Valyrian Pod in use.

Uwell's Pro-FOCS Coil

Both coils are fitted with Pro-FOCS, Uwell's flavour technology, designed for flavour that stays true to your e-liquid. Uwell puts it in the coil on this platform, so both resistances have it.

10 Minutes After Filling

Fitting a fresh coil is quick. Remove the old coil from the bottom of the pod and push the new one firmly into place. Slide the top cap open, fill the pod and close it again, then leave it to stand for 10 minutes before vaping so the liquid can soak in. Those 10 minutes help prevent a dry hit on a new coil.

When should I change the coil?

When the flavour starts to fade, the coil is on the way out. Carry on and a burnt taste comes through. Change the coil at that point. Heavily sweetened e-liquids shorten a coil's life, and chain vaping will get through them faster.

How do I adjust the draw?

Adjust the airflow on the side of the pod: close it down for a tighter draw, or open it up for a smoother one, whichever coil is fitted. The kit has a maximum output of 25 W and no wattage to set, so the airflow is what you have to work with.